Sagging runs, pulled hangers, and re-pitching
Older installs in the Valley rely on long spikes driven through the face of the gutter into the fascia. Every summer day the aluminum and the wood expand and contract at different rates, and over years the spikes back out. The run tips forward, water pools in the low spot, and the added weight of standing water and grit speeds the whole thing up. The fix is to pull the spikes, check the fascia behind them, and re-hang the run with hidden hangers screwed into solid wood. If the fascia has gone soft from years of a wet trough sitting against it, we replace that section first, because a new screw in rotted wood holds for about one storm. Re-pitching is part of the same visit: once the run is re-hung we reset the fall toward each outlet and flush out the packed grit that was holding water.
Leaking corners, end caps, and old sectional seams
Even a seamless gutter has joints at the corners, the end caps, and the outlet. Sectional gutters have one every ten feet. All of those are sealed, and sealant is what Phoenix sun attacks hardest, especially on south and west walls. The tell is a rust-colored streak or a wet stripe on the stucco directly under a corner. We clean the joint back to bare metal, reseal it with a high-temperature gutter sealant, and rivet anywhere the metal has pulled apart. On old sectional runs we can reseal every seam in one visit. If the seams are all failing together we will show you what replacing that run with a single seamless piece costs, and let you decide.
Crushed, clogged, and disconnected downspouts
Downspouts are where a system chokes. A bird nest or a wad of palo verde litter in the top elbow backs water up the whole run. Ground-level elbows get flattened by trash cans and mowers, and a disconnected section dumps the roof right at the foundation. We clear or replace elbows and sections, reattach straps, and add extensions or splash blocks so the water lands clear of the slab. When one 2x3 downspout is trying to drain a long run or a valley, we add a second outlet or upsize to 3x4, because no amount of cleaning fixes an outlet that is too small for a monsoon cell.
Repair or replace? The honest test
Repair is usually the better value, and we would rather fix what you have. Use this test.
- Repair it if the metal is straight, the fascia is solid, and the problem is one corner, one outlet, one sagging stretch, or dried sealant. All of that is a service call.
- Replace the run if the trough is dented along its length, corrosion has opened the bottom, the fascia and the gutter are failing together, or the seams on an old sectional system are all going at once.
- Replace with 6-inch if a clean, properly pitched 5-inch run still overflows every storm. That is a capacity problem, and repair cannot fix capacity.
What you get
- Hidden hangers into solid wood replace backed-out spikes, so the run stays put through heat cycling
- Corners and end caps resealed with high-temperature sealant and riveted where the metal has separated
- Crushed or missing downspout sections, elbows, and straps replaced to match the existing color
- Runs re-pitched and flushed so water reaches the outlet instead of sitting in a sediment bed
- Outlets added or upsized to 3x4 where one downspout cannot keep up with the roof section
- A plain repair-or-replace answer at the estimate, priced both ways when it is close
How it goes
- 01
Look at the whole run
We check pitch, fasteners, fascia, every joint, and every downspout from top elbow to grade, not only the spot that is leaking.
- 02
Written repair scope
You get a list of what is wrong and what each fix involves. If replacement is the better spend, we say so and price both.
- 03
Repair in one visit
Re-hang, reseal, re-pitch, replace downspout sections, add outlets. Most repairs are finished the same day we start.
- 04
Water test and photos
We run a hose through each section to confirm flow at the outlets and leave you photos of the finished work.
Google reviews
From the Google reviews
-
“Grant from Blueberry came out and repaired my gutter. It was a small job and those other so called “local” companies didn’t even call back. From online form to complete in less than 2 hours!”
Tim D. · Google review
-
“Blueberry did a fantastic job on my place in North Phoenix, if you need rain gutters give them a call!”
Andrew S. · Google review
Questions we get asked
How much does it cost to repair a gutter in Phoenix?
It depends on what failed. Resealing a corner or clearing a downspout is a short service call. Re-hanging a long sagging run with new hidden hangers takes longer, and replacing rotted fascia behind it adds carpentry. We price repairs after looking at the run, in writing, before any work starts.
Can a gutter be repaired, or does it need to be replaced?
Most can be repaired. Sagging, leaking corners, dried sealant, and crushed downspouts are all fixable on a sound gutter. Replacement makes sense when the trough is dented along its length, corrosion has opened the bottom, or a 5-inch run overflows even when it is clean and pitched correctly.
What are the most common problems with rain gutters in Arizona?
Four things cause nearly every call: spikes that heat cycling has walked out of the fascia, corner and end-cap sealant that the sun has cracked, roof grit and dust compacted into a bed that blocks the outlet, and downspouts that are clogged, crushed, or too small for the roof section they drain.
Do you repair gutters that another company installed?
Yes. Much of our repair work is on systems somebody else installed, often builder-grade sectional gutters or spike-hung runs from years ago. We work on any aluminum gutter in Phoenix and the North Valley, match downspout and elbow colors as closely as stock allows, and tell you if the run is past saving.
Why does my gutter overflow in the middle of the run?
A dip. Once a hanger lets go, the run sags between the remaining fasteners, water pools in the low spot, and the next storm goes over the front lip there. Sediment packed in the trough does the same thing. The fix is re-hanging and re-pitching the run, then flushing it, so water reaches the outlet again.
Related
Where we do this work
Gutter Repair across Phoenix and the North Valley: North Phoenix, Cave Creek, Scottsdale, Anthem, New River, Glendale, Desert Hills, Peoria, Surprise, Deer Valley, Mesa, Gilbert, and the neighborhoods between them. See the full service area.
